Jump to content

 

Photo
- - - - -

DIY led panel

Started By Elevator dude , Jun 30 2018 03:08 PM

  • Please log in to reply
150 replies to this topic

#151 MDS

MDS

    Internode Master...

  • Banned
  • PipPipPipPipPipPipPipPip
  • 2,529 posts
  • Thanks: 12481

Posted 31 July 2018 - 10:43 PM

I'd run a thicker cable to what you guys call a terminal block, can't remember it as it's alien to me (wago?)... I'd suggest 2.5mm^2, again I'm not sure of that in AWG... But given the right cable that's good for 32A, insulation dependent!

 

Then from the block use thinner cable to each bank of LEDs & resistors... Each cable run should need no more than 0.5mm^2 which is good for 6A...

 

It'll reduce the losses :)


  • Dex and Horse Badorties like this
Back to Grow Room Design and all things DIY.
  1. The Green Circle
  2. → Train
  3. → Guides/Techniques
  4. → Grow Room Design and all things DIY.
  5. Privacy Policy
  6. TGC Forum Rules ·
IPB Skin By Virt
Disclaimer: You must be over 18 years old to view/use this website. T-G-C.nl does not encourage growing cannabis or possessing cannabis, Learning how to grow cannabis is purely for educational purposes. All information on this website is strictly for: Historical reference, Scientific reference and educational purposes. Please check the laws in your own country as T-G-C.nl is in no way responsible for repercussions of accessing the website. All information is stored on a secure server in Amsterdam. We advise all visitors against breaking the law.